Alex Wiebe: December 2012 Archives

Blogging on the mill (treadmill this time)

|
| Comments (0)
Latest winter project - a laptop stand for the treadmill.
Youtube on the tread mill
A simple frame of 2 vertical beams made from 1/8" x 1" aluminum flatbar, joined horizontally by 1/16" x 3/4" aluminum angle bars which was then attached to the top of the treadmill with a couple angle brackets.
Youtube on the tread mill

Home made spot welder

|
| Comments (0)
Over the past few weeks I've been building a spot welder. A rather simple, brute force device that fuses couple thin sheets of metal together by pumping a tonne of current. We're talking 1,000 Amps of current. Now where does one find that much current lying around.... Well, conserving power, we can produce that much current if we step down the voltage from the mains. If we took 120V @ 15A (~1,800Watts) and stepped it down to 1.2V, we could in theory pull 1,500Amps! So where does one find a transformer with a primary capable of drawing 15A?

The start

From a microwave! The first thing to do with the transformer, is to remove the high voltage secondary. The easiest way to do this, is to carefully chisel the exposed coil off, and then use a punch to push out the internal windings.

PB180003

When done you should have a good primary coil and two holes to rewind the secondary coil.

PB210006

Now wind some heavy (I used 6 gauge wire, but 4 or 2 would be better). This is not easy - that stuff is stiff. Finally add some heavy copper lugs and tips to press into the metal.

Final setup.

And you're done!

Welding 24 (or 22?) gauge tin

I have sort of weld 24 gauge tin and definitely blow a hole through soup can lids. It should be good enough for making small tin boxes.